Studying The Quality of Transmitted Signal Via a Wireless and Wired Lines
DOI:
https://doi.org/10.58916/jhas.v8i3.163الكلمات المفتاحية:
optical wire، wireless control system communicationالملخص
Abstract: A communication system refers to the process of exchanging information between two or more parties. Wired communication systems use physical cables or wires to transmit signals, while wireless communication systems transmit signals through the air without the use of physical cables. Both wired and wireless communication systems have their advantages and disadvantages, and the choice of system depends on the specific requirements of the application. In this research, a full compression between wired and wireless signals are discussed.
التنزيلات
المراجع
Lee F.C., “Power Electronics System - Introduction”, Virginia Tech,2005.
“Power Electronics System-A Joint Course”, taught by Virginia Polytechnic
Institute and State University (Virginia Tech), 2005.
J. M. Tour, M. Kozaki and J. M. Seminario, “Molecular Scale Electronics:
A Synthetic/Computational Approach to Digital Computing”, J Am Chem
Soc, pp. 8486-8493, 1998.
‘P.O.12.3 Requirements Regarding Wind Power Facility Response To Grid
Voltage Dips Proposal Sent To Ministry,’ BOE, Num. 254, Oct. 2006, pp. 37017-
T. Kostyrko, B. Bułka, “Current fluctuations of polymeric chains”, Phys.
Rev. B, Vol. 67, 2555-2561, 2003.
W. B. Davis, W. A. Svec, M. A. Ratner and M. R. Wasielewski, “Molecular-wire
behaviour in p-phenylenevinylene oligomers”, Nature, Vol. 396, pp. 60-63, 1998.
R. A. Marcus, Chem. Phys. Lett., Vol. 133, pp. 471, 1987.
K. V. Mikkelsen, M. A. Ratner, “Molecular Electronics”, Chem. Rev, Vol. 81, pp.
, 1987.
التنزيلات
منشور
إصدار
القسم
كيفية الاقتباس
